.

Saturday, April 13, 2013

Sedimentation

I.AbstractSedimentation is the process of separating a liquid mixture of suspended particles into overhaul supernatant liquid and denser slurry having a higher concentration of solids. This is ordinarily accomplished by allowing the particles to settle through the force of gravity, mechanically use centrifugal force, or electrostatically using an electrical current. Continuous sedimentation tanks are usually used in wastewater treatment facilities to sepa step suspended particles from wastewater.

This experiment aims to confine the effect of sign concentration and initial height of the slurry on its settling characteristics. Using a set of data obtained from the experiment, a continuous thickener or clarifier must then be designed. The batch sedimentation experiment was accomplished by mensuration the height of the clear liquid interface at two-minute intervals using initial concentrations of 25, 50, and 75 grams per liter and initial volumes (convertible to height) of 1000, 900, and 800 milliliters. Two trials were conducted for separately matrix.

From the data, it was observed that as the initial concentration of slurry is increased, the initial settling velocities decrease. The initial height has no effect on the initial settling velocity but can affect the rate at which solids compact. However, it was found that how the height affects compaction can be unpredictable.

Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!

For the design of a thickener using batch sedimentation data, the required area was calculated using the Coe and Clevenger, and the Talmadge and Fitch methods. The results were 1.3112 m2 and 2.2714 m2, respectively.

During the pedigree of the experiment, various problems were encountered that may have lead to unconvincing errors. These problems were usually problems of measurement. Using masking tape can cause slight errors if not applied to the cylinder properly. There were slight difficulties during the initial stirring of the slurry because of the lack of long stirring rods. Furthermore, results from...

If you want to shake up a full essay, order it on our website: Ordercustompaper.com



If you want to get a full essay, wisit our page: write my paper

No comments:

Post a Comment